HP xw4200 Especificações Rápidas descarregar pdf (Página 48)

4–14 www.hp.com Getting Started Guide

Troubleshooting

Red Power LED

blinks once every

two seconds.

None Power failure

(power supply

overloaded).

1. Check that the voltage

selector, located on the

rear of the power

supply, is set to the

appropriate voltage.

Proper voltage setting

depends on your

region.

2. Open the hood and

ensure the 4-wire

power supply cable is

seated into the

connector on the

system board.

3. Check if a device is

causing the problem by

removing ALL attached

devices (such as hard,

diskette, or optical

drives, and expansion

cards.) Power on the

system. If the system

enters the POST, then

power off and replace

one device at a time

and repeat this

procedure, until failure

occurs. Replace the

device that is causing

the failure. Continue

adding devices one at

a time to ensure all

devices are functioning

properly.

4. Replace the power

supply.

5. Replace the system

board.

Activity Beeps

Possible

Cause

Recommended

Action

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 61 62

Comentários a estes Manuais

Sem comentários

HP xw4200 Especificações Rápidas Página 48

Comentários a estes Manuais

Manuais e produtos relacionados com Barebones PC/estação de trabalho HP xw4200