HP SuperStack 3 Load Balancer Appliance Manual do Utilizador descarregar pdf (Página 21)

The Power-up Sequence 21

The Power-up

Sequence

The following sections describe how to get your Server Load Balancer

powered-up and ready for operation.

WARNING: If you are connecting the Server Load Balancer to a ARPS

Type 3 Power Module, read the Safety Information section in the

documentation shipped with the power system.

Powering-up To power-up the Server Load Balancer, complete the following steps:

1 Plug the power cord into the power socket at the rear of the unit.

2 Plug the other end of the power cord into your power outlet.

The unit powers-up and runs through its Power On Self Test (POST),

which takes approximately 10 seconds.

During the POST, all ports on the Server Load Balancer are disabled and

the LEDs light in a rapid sequence. See “LEDs” on page 14.

When the POST has completed, check the Power/Self Test LED to make

sure that your Server Load Balancer is operating correctly. See “Solving

Problems Indicated by LEDs” on page 22.

slb_gsg.bk Page 21 Thursday, May 31, 2001 8:57 AM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 98 99

Sem comentários

HP SuperStack 3 Load Balancer Appliance Manual do Utilizador Página 21