HP SuperStack 3 Load Balancer Appliance Manual do Utilizador descarregar pdf (Página 62)

62 CHAPTER 8: CONFIGURING FOR LOAD BALANCING

Defining a Server

Subnet

Before you can add a server, you need to have defined at least one server

subnet. The default gateway of each server must be set to the floating

default gateway address of the Server Load Balancer.

To define a server subnet, complete the following steps:

1 Click Logical View on the Toolbar.

2 From the Navigation tree, select Server Load Balancing > Setup -> Server

Subnets.

3 Click Add. The first wizard page appears.

4 Click Next. The Server Subnet - Define Subnet page appears.

5 Enter 192.168.2.254 in the IP Address field.

If configuring for a redundant configuration, you need to enter the IP

addresses of both Device A and Device B.

6 Enter 255.255.255.0 in the Subnet Mask field.

7 Click Next. The Server Subnet - Device A Floating Address page appears

8 Complete the entry in the Floating Address field. For example,

192.168.2.200.

Do not forget to change the default gateway on your servers to this IP

address

9 Click Finish. Your server subnet has been added.

slb_gsg.bk Page 62 Thursday, May 31, 2001 8:57 AM

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 98 99

Sem comentários

HP SuperStack 3 Load Balancer Appliance Manual do Utilizador Página 62