HP 200 Manual do Utilizador descarregar pdf (Página 253)

100

101

Disable: Disabling Configured Entities

Use NCL’s Disable command to remove a routing service, a circuit, an

X.25 point-to-point virtual circuit, or another configured software object

from service. (You cannot use Disable to disable a line.) On the HP

Router 650, you can also enable a previously disabled interface module

slot.You need to identify the object by its management information base

(MIB) variable name or object identification code. See “Managed

Objects Table” on page 16-32 and the List command on page 16-35 for

object names, codes, and pathnames.

Syntax

disable identifier

identifier is the pathname identifying the software object. You

can use object identification codes and/or object names.

Examples

disable ip Disables the IP router.

disable 5 (5 is the equivalent object

identification code for ip.)

disable cct.ether1 cct.wan1 Disables the circuits named

“Ether1” and “WAN1”.

disable echo Disables TCP echo service.

disable pm.2 Disables the interface module

in slot 2 (HP Router 650 only).

Edit: Invoking the Configuration Editor

Use NCL’s Edit command to switch to the Configuration Editor menu, as

if you had chosen “Configuration Editor” from the Main menu, but

without leaving NCL. Refer to the User’s Guide for information on how

to use the Configuration Editor. When you choose “Exit without Saving”

or “Save and Exit”, you will return to the NCL prompt rather than to the

Main menu.

Syntax

edit

Using the Network Control Language

Managing Router Operations and Resources

16-8

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 675 676

Comentários a estes Manuais

Sem comentários

HP 200 Manual do Utilizador Página 253

Comentários a estes Manuais

Manuais e produtos relacionados com Software HP 200