HP 200 Manual do Utilizador descarregar pdf (Página 272)

100

101

Telnet: Establishing a Virtual Terminal

Connection

Use NCL’s Telnet command to establish a Transmission Control Protocol

(TCP) virtual terminal connection to a remote node, allowing you to

interact with the remote nodes interface. This router must have IP

routing and a Telnet session configured. This router supports a

maximum of four simultaneous TCP connections. The remote node must

have Telnet service.

Syntax

telnet X.X.X.X

X.X.X.X is the IP address of the remote node in dotted decimal

notation.

Example

telnet 15.3.0.97

Once a connection is established, Telnet passes keystrokes from your

router to the remote node.

If the remote system is another HP router, you will see the system

name of the remote node as the NCL prompt at the bottom of the

display. You can use the same commands that you use on your own

router. You can use NCL’s Exit command to exit NCL and access the

Main menu on the remote router.

To disconnect, select “Logout” from the Main menu. At:

Do you want to disconnect? [Y/N:]

answer [Y] for yes. The remote node and Telnet are disconnected, and

you will see your own system name on the the display.

If the remote system is not another HP router, then type the appropri-

ate commands to interact with that system. Disconnect Telnet when

you are finished. When Telnet is disconnected, you will see your own

system name on the display.

NCL

Commands

Using the Network Control Language

Managing Router Operations and Resources

16-27

1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 675 676

Comentários a estes Manuais

Sem comentários

HP 200 Manual do Utilizador Página 272

Comentários a estes Manuais

Manuais e produtos relacionados com Software HP 200