HP 4000M Manual do Utilizador descarregar pdf (Página 152)

6-76

Configuring the Switch

Load Balancing: Port Trunking

Configuring the Switch

6. Move the cursor to the Type column for the selected port and use the

Space bar to select the trunk type:

– Trunk (Source Address/Destination Address trunk; the default

type if you do not select a type)—page 6-77.

– SA-Trunk (Source-Address trunk)—page 6-78

– FEC (Fast EtherChannel

trunk)—page 6-79

All ports in the same trunk must have the same Type (Trunk, SA-Trunk, or

FEC).

Figure 6-51. Example of trunks with different trunk types

7. When you are finished assigning ports to trunks, press [Enter], then [S] (for

ave) and return to the Main Menu. (It is not necessary to reboot the

switch.)

During the Save process, traffic on the ports configured for trunking will

be delayed for several seconds. If the Spanning Tree Protocol is enabled,

the delay may be up to 15 seconds.

8. Connect the trunked ports on the switch to the corresponding ports on

the opposite device. If you previously disabled any of the trunked ports

on the switch, enable them now. (Refer to “Port Settings” on page 6-30.)

9. Check the Event Log (page 8-12) and the Switch Mesh Information screen

(page 7-22) to verify that the trunked ports are operating properly.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 303 304

Sem comentários

HP 4000M Manual do Utilizador Página 152