
configuring X Windows on HP-UX (other graphics cards)
display power management signaling (DPMS)
Chapter 356
display power management signaling (DPMS)
Monitors constitute a large percentage of the power used by a
workstation even when not actively in use (i.e. during screen blanking).
In order to reduce the power consumption, the Video Electronic
Standards Association (VESA) has defined a Display Power Management
Signaling (DPMS) standard which can be used to greatly reduce the
amount of power being used by a monitor during screen blanking.
The following table is a description of the states that are defined by
VESA. The Power Savings column indicates (roughly) the level of power
savings achieved in the given state. The Recovery Time is the amount of
time that the screen takes to return to a usable state when the screen
saver is turned off (by pressing a key or the moving the mouse).
The actual amount of power saved and the recovery time for each of the
states is monitor dependent and may vary widely. The customer can
compensate for this by choosing an appropriate level for the monitor that
is currently in use.
By default, the DPMS level used is the Screen Saver (i.e. no power
savings). If you wish to use power saving during screen blanking, set the
following XF86Config file entries before starting the server: blank time,
standby time, suspend time, and off time.
The DPMS Extension lets individual users customize their personal
DPMS settings to meet their work styles and any restrictions imposed by
their employers. For example, an employer may decide that all monitors
must save power after 30 minutes of idle time. The individual user may
decide that 30 minutes is too long, and adjust the time downward to meet
their work preference.
Table 3-4
Level State DPMS Compliance
Requirements
Power
Savings
Recovery Time
0 Screen Saver Not Applicable None Very Short (<1 sec)
1 Standby Optional Minimal Short
2 Suspend Mandatory Substantial Longer
3 Off Mandatory Maximum System Dependent
GAG11.book Page 56 Tuesday, February 14, 2006 9:11 AM
Comentários a estes Manuais