
NOTE:
You can specify the host name instead of the fixed IP address if the fixed IP address and the corresponding
host name are registered in /etc/hosts,anNISserver,oraDNSserver. Seethe
NAS Blade
Manager User's Guide
for information about registering the fixed IP address and the corresponding host
name in /etc/hosts andhowtheNASBladesystemcansearchthehostnameusingNISorDNS.
Based on Table 38, change each entry of ip_address in HORCM_MON to an appropriate value. For
the entry service in HORCM_MON and the entry in HORCM_CMD, appropriate values are specified
when NAS Backup Restore is installed.
Change the entries poll and timeout to the appropriate values according to hardware requirements.
Table 39 Example 1: RAID Manager XP configuration definition file (for instance
number 16)
HORCM_MON
#ip_address service poll(10ms) timeout(10ms)
123.456.78.51 20331 1000 3000
HORCM_CMD
#dev_name dev_name dev_name
#UnitID 0 (Serial# 62486)
/dev/sdf
HORCM_DEV
#dev_group dev_name port# TargetID LU# MU#
# /dev/sdj SER = 62486 LDEV = 70 [ FIBRE FCTBL=3]
VG VG_000 CL1-A-1 0 0
# /dev/sdk SER = 62486 LDEV = 18 [ FIBRE FCTBL=3]
VG VG_001 CL1-A-1 0 1
?
?
# /dev/sdw SER = 62486 LDEV = 66 [ FIBRE FCTBL=3]
VG VG_013 CL1-A-1 0 13
# /dev/sdx SER = 62486 LDEV = 14 [ FIBRE FCTBL=3]
VG VG_014 CL1-A-1 0 14
# /dev/sdy SER = 62486 LDEV = 68 [ FIBRE FCTBL=3]
VG VG_015 CL1-A-1 0 15
# /dev/sdz SER = 62486 LDEV = 16 [ FIBRE FCTBL=3]
VG VG_016 CL1-A-1 0 16
HORCM_INST
#dev_group ip_address service
VG 127.0.0.1 52323
Next, delete unnecessary LU entries (lines) for the HORCM_DEV section, except for the LU entry (line) you
want to control using RAID Manager XP (see Table 41).
LUs constituting a file system and their LDEV numbers can be reviewed using the following command.
$ sudo horc_devlist | grep ':File System Name$'
For example, in Table 40, 11, 12, and 13 are LUs constituting the file system sample. Their LDEV numbers
are 64, 12, and 66.
Continuous Access XP Journal user guide
193
Comentários a estes Manuais