HP Remote Graphics Software (RGS) Manual do Utilizador descarregar pdf (Página 37)

Using smart card redirection (Windows only)

When smart card redirection is enabled, both the receiver and sender can access the same smart card that

physically exists on the receiver-side only. This means that you can unlock the receiver desktop using the

smart card, connect to the sender, and then use the same smart card with the sender desktop.

NOTE: Smart card redirection can be used with standard authentication or Easy Login only. It cannot be

used with Single Sign-on.

To use smart card redirection:

1. Enable smart card redirection during the installation of both RGS Receiver and RGS Sender (see

Installation on page 6).

2. Install the vendor driver for the smart card reader on the receiver.

3. Install the vendor driver for the smart card on both the receiver and sender.

4. If Remote USB is enabled, see Conguring Remote USB for smart card redirection on page 27

NOTE: If the smart card removal policy has been set on the receiver, the receiver desktop is locked if the

smart card is removed. If the smart card removal policy has been set on the sender, the sender desktop is

locked when the RGS connection is ended.

Conguring Remote USB for smart card redirection

Smart card readers typically connect to the system via USB, so you must prevent the smart card reader from

being remoted by the Remote USB feature to use the smart card redirection feature.

To prevent the smart card reader from being remoted:

▲

If you used the default Remote USB installation option USB devices are Local/Remote when installing

RGS Receiver, connect the smart card reader to the receiver before starting an RGS session, and do not

disconnect the smart card reader during the session.

– or –

Set the remoting behavior of the smart card reader to local (see Conguring the remoting behavior of

individual USB devices (Windows only) on page 40).

Limitations

Consider the following limitations when using smart card redirection:

●

Smart card redirection is limited to the primary user.

●

Smart card redirection is limited to the rst smart card reader device detected by the system.

●

Disconnecting and reconnecting a smart card reader during an RGS session causes the smart card reader

to be remoted via Remote USB. In this situation, the receiver no longer sees the smart card reader or

smart card. If the smart card removal policy is enabled, the receiver desktop locks.

●

Smart card redirection does not work with User-Mode Driver Framework (UMDF) drivers, which includes

native Windows smart card drivers.

Authentication 27

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 96 97

Sem comentários

HP Remote Graphics Software (RGS) Manual do Utilizador Página 37