Hp Integrity rx4610 Server Manual do Utilizador descarregar pdf (Página 24)

3 Installing Fans and Power Supplies

Introduction

The fans and power supplies used by the HP Server are hot swappable. The HP Server has four 172

mm fans located on each side of the chassis and two 120 mm cooling fans located on the top front of

the chassis. The server has a maximum of four 800 watt autoranging power supplies located in the

front of the chassis. This chapter describes the procedures necessary to remove and to replace these

components.

Tools and Supplies Needed

• Phillips (cross-head) screwdriver (#2 bit)

• Antistatic wrist strap (recommended)

• Pen or pencil

• Equipment Log

To record the model and serial numbers of the server, all installed options, and any other pertinent

information about the server, see Appendix B, “Equipment Log and Configuration Worksheet”.

WARNING Make sure that the rack is anchored securely, so it will not tip when the server

chassis is extended.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 200 201

Sem comentários

Hp Integrity rx4610 Server Manual do Utilizador Página 24