Hp NonStop G-Series Manual do Utilizador descarregar pdf (Página 73)

Switch Command Interface (SWCI)

ServerNet Nomadic Disk (Release 2) User’s Guide—523968-001

6-3

Configuring the ATP6100 Line for SWCI

Communications

Configuring the ATP6100 Line for SWCI

Communications

The SWAN and SWAN 2 concentrators use an asynchronous ATP6100 line to provide

communications between SWCI running on the primary and backup nodes and a

switch module. If the ATP6100 line is not already configured, perform the following

steps at both the primary node and backup node.

1. Use HP TSM to check the configuration of the EtherNet 4 ServerNet adapter

(E4SA) and the SWAN or SWAN 2 concentrator. If TSM shows a configuration

problem, refer to the following:

•

For information about configuring an E4SA, refer to Ethernet Adapter (E4SA)

Hardware Installation and Support Guide and LAN Configuration and

Management Manual.

•

For information about configuring a SWAN or SWAN 2 concentrator, refer to

the SWAN Concentrator Installation and Support Guide or SWAN 2

Concentrator Installation and Support Guide, WAN Subsystem Configuration

and Management Manual, and WAN Wizard User’s Guide.

2. Create a PATPTERM profile.

The required values for the device and the interface type for the ATP6100 line are

included in the PATPTERM profile.

Parameter Variable Value Profile Modifier

Device type 6 (terminal) DEVTYPE 6

subtype 0

(asynchronous

serial device)

DEVSUBTYPE 0

Interface type RS-232-C EIA

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 147 148

Sem comentários

Hp NonStop G-Series Manual do Utilizador Página 73