HP 425 Especificações descarregar pdf (Página 105)

2. Remove the Phillips PM2.0×3.0 screw (1) that secures the board to the base enclosure, disconnect

the audio ZIF connector and remove the flat-ribbon cable (2) from the system board.

3. Remove the optical drive extender on the 35.6-cm (14.0-in) computer by first removing the

Phillips PM2.0×3.0 screw (1) that secures the extender to the base enclosure.

NOTE: 33.8-cm (13.3-in) computers do not use an optical drive extender.

4. Lift the system board slightly and then pull the extender straight out (2) from the system board.

5. Release the RJ-11 cable from the cable routing area, lift the connector from the base enclosure (1),

and disconnect the connector (2) from the system board.

6. Lift the system board at an angle (3) and disconnect the main battery cable (4) from the bottom of

the board.

Component replacement procedures

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 164 165

Sem comentários

HP 425 Especificações Página 105