HP K7 Manual do Utilizador descarregar pdf (Página 106)

The "Using Correct Type of Phone Cord with Fax" test failed

Solution:

• Make sure you used the phone cord supplied in the box with the device to connect

to the telephone wall jack. One end of the phone cord should be connected to the

port labeled 1-LINE on the back of the device, and the other end to your telephone

wall jack, as shown below.

1 Telephone wall jack

2 Use the phone cord supplied in the box with the device to connect to the "1-LINE" port

If the phone cord that came with the device is not long enough, you can use a

coupler to extend the length. You can purchase a coupler at an electronics store

that carries phone accessories. You will also need another phone cord, which can

be a standard phone cord that you might already have in your home or office.

• Check the connection between the telephone wall jack and the device to make

sure the phone cord is secure.

• Make sure you use the phone cord that came with the device. If you do not use

the supplied phone cord to connect from the telephone wall jack to the device,

you might not be able to send or receive faxes. After you plug in the phone cord

that came with the device, run the fax test again.

• If you are using a phone splitter, this can cause faxing problems. (A splitter is a

two-cord connector that plugs into a telephone wall jack.) Try removing the splitter

and connecting the device directly to the telephone wall jack.

Chapter 7

102 Solve a problem

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 227 228

Sem comentários

HP K7 Manual do Utilizador Página 106