HP SA9200 Guia de Início Rápido descarregar pdf (Página 13)

Interacting with the SA9200

To interact with the SA9200, you need a terminal emulator (such as

HyperTerminal) on your PC. The instructions below are for

HyperTerminal.

1. Type any character in the Name field of the Connection Descrip-

tion window, and click OK. The Phone Number panel appears.

2. In the Connect To box specify “Direct to COM1” (or the serial

port through which the PC is connected to the SA9200 if

different from COM1).

3. Click OK. The COM1 Properties panel appears.

4. Click Restore Defaults. (Values should be 9600 bits per second,

8 data bits, parity set to “none.” and 1 stop bit [9600-8-N-1].)

5. Click OK.

The SA9200 is now ready for initial configuration with the

monitor> prompt displayed.

Boot

Configuration

Steps (Boot

Monitor)

The Boot Monitor Command Line Interface (CLI) must be used to

perform the initial configuration of the SA9200. After initial

configuration, you should seldom need to access the Boot Monitor.

Follow the prompts as shown in the following example. User inputs

appear in bold, an empty space after the “--->” prompt indicates

that the user accepted the default by pressing <Enter>. The final step

of configuration is restarting the device. This step must occur for the

configuration to take effect.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Sem comentários

HP SA9200 Guia de Início Rápido Página 13