HP SA9200 Guia de Início Rápido descarregar pdf (Página 17)

Automatic Configuration of the SA9200

Automatic Configuration of

the SA9200

There are two methods for configuring the SA9200, often used in

combination:

• Automatic: Quick Start Wizard default configuration

• Manual or custom configuration

For instructions on manually configuring the SA9200, or modifying

an existing configuration, see Chapter 3, “CLI Configuration,” in the

User Guide.

Quick Start

Wizard

The Quick Start Wizard is an interactive default configuration tool

that allows you to configure the SA9200 with default settings by

responding to specific prompts. After the default configuration, you

can specifically customize certain configuration parameters to

conform to the needs of your particular site.

Before you start up the wizard, you should complete the Pre-

Installation Checklist” on page 7 and “Site Survey” on page 9. Create

a network topology map containing the location of all components of

your SA9200.

In the Quick Start Wizard, you are asked to enter the information you

have outlined on your network topology map. Next, you can begin to

configure any number of distributed sites (e.g. www.xyz-ex.com). As

each site is configured, you are asked for load balancing criteria and

which load balancers are to take part in the multi-site load balancing.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Sem comentários

HP SA9200 Guia de Início Rápido Página 17