HP EML Base Library Guia de Início Rápido descarregar pdf (Página 5)

5 Plug in the OCP cables

1. Remove the two T-10 Torx screws from the bottom-left and top-right

corners of the black protective cover that is on the back of the

Operator Control Panel (OCP).

2. Remove the two T-15 Torx screws from the metal cover on the upper

door to access the cables.

3. Plug the two ribbon cables into the back of the OCP.

4. Fold the cables so they fit under the covers. Replace the metal cover

and the black protective cover.

6 Insert the lift pole

Inside the front of the library, insert the lift pole onto the pole mount at

the lower left corner of the back wall of the 4U base module. Press down

on the pole until the top of the pole slips into the pole mount in the 8U

base module above it.

7 Plug in the inter-module power cable

1. Remove the two bottom arrays from the back column of arrays on

the right wall. (You are removing one 6-slot array from the 8U base

module and one 6-slot array from the 4U base module.) To remove

an array, press its release lever and lift up on the array.

2. Plug in the two ends of the power cable.

WARNING!

Before doing this step, make sure the main power switch

is Off and the 8U base module is not plugged in.

3. Replace the arrays inside the library.

8 Plug in the interconnect cable

1. At the rear of the library, loosen the thumbscrew and remove the

cover from the bottom-left corner of the 8U base module.

Page 5

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

HP EML Base Library Guia de Início Rápido Página 5