HP EML Base Library Guia de Início Rápido descarregar pdf (Página 9)

• Plug each power supply into a power strip (power cable included).

Plug each power supply into a different power strip. You cannot plug

the power supplies directly into the wall outlet.

• If it’s not already plugged in, plug each power strip into the rack’s

power distribution unit (PDU). And plug the PDU into an AC outlet.

If you have more than one power distribution unit (PDU), plug each

PDU power cable into a different AC power circuit to establish re-

dundancy.

14 Attach the bar code labels to the tape

cartridges

CAUTION:

Handle tape cartridges with care. Do not drop or mishandle

them, or place them near sources of electromagnetic

interference. Rough handling can damage the tape cartridge

making it unusable and potentially hazardous to the tape drives.

CAUTION:

The misuse of bar code technology can result in backup and

restore failures. To ensure that your bar codes meet HP’s quality

standards, always purchase them from an approved supplier

and never print bar code labels yourself. For more information,

see the order form provided with the library, as well as the

Bar

Code Label Requirements, Compatibility and Usage

white paper

available from http://www.hp.com/support.

Attach a bar code label to each tape cartridge. Place the bar code label

entirely within the recessed area.

15 Insert the tape cartridges into the slots

IMPORTANT:

Do not insert tape cartridges into the 4U base module.

At the front of the library, insert the tape cartridges into the slots on the

side walls inside the 8U base module.

16 Power on the library

1. Keep the center door of the library open and turn the center-door

knob one-quarter turn counterclockwise to raise the door-locking

lever that is on the top of the center door.

2. Close the center door of the library and turn the centerdoor knob

one-quarter turn clockwise to lock it.

3. At the rear of the library, turn on the main power switch.

NOTE:

Your library might look different.

17 Initial Interface Manager card setup

If an IPv4 DHCP network is available and the fault LEDs are not

illuminated, verify that the NETWORK port on the Interface Manager

card is connected to that DHCP network for proper setup. Skip the rest

of this step.

Page 9

1 2 3 4 5 6 7 8 9 10 11

Comentários a estes Manuais

Sem comentários

HP EML Base Library Guia de Início Rápido Página 9

Comentários a estes Manuais

Manuais e produtos relacionados com Redes HP EML Base Library