HP EML Base Library Guia de Início Rápido descarregar pdf (Página 8)

2. Attach the cable clamps to the right rear rack at the positions 37T,

26T, and 15T. Use these cable clamps to route the tape drive

Ethernet cables.

13 Connect the cables

CAUTION:

To avoid damaging Fibre Channel (FC) cables, do not pinch

or sharply bend the cable tighter than a 5-centimeter (2-inch)

diameter. Allow a radial bend when attaching an FC cable to

a cable clip.

2. e2400-FC 4Gb interface con-

troller

1. Library robotics controller

4. Interface Manager card3. To hosts

6. Tape Drives

5. To management station, via

customer LAN

Figure 1 e2400-FC 4Gb cable connections

2. Library robotics controller1. Switch for the internal network

4. To host

3. e2400-FC 2Gb interface con-

troller

6. To management station, via

customer LAN

5. Interface Manager card

8. Tape drives7. Port A to SAN

10. To port 2 on the switch9. To port 1 on the switch

Figure 2 e2400-FC 2Gb cable connections

Make the following connections. Attach labels to the ends of each cable.

• LTO3 tape drives only: Plug an FC cable (included) into the FC port

on a tape drive and into a TD# port on the interface controller (middle

card in the card cage). Repeat for each tape drive.

• LTO4 and LTO5 tape drives only: Plug an FC cable (included) into

the FC Port A on a tape drive and into the SAN. Repeat for each

tape drive.

• LTO4 and LTO5 tape drives only: Plug an Ethernet cable from the

MGMT port on the tape drive to the switch for the internal network.

Plug in the tape drives in order starting with the top tape drive going

to port 1 on the switch.

• LTO4 and LTO5 tape drives only: Plug an Ethernet cable from port

24 on the switch for the internal network to one of the TO CONTROL-

LER/DEVICE PORTS ports on the Interface Manager card (bottom

card in the card cage).

• Plug an Ethernet cable (included) into the Ethernet port on the interface

controller (middle card) and into the TO CONTROLLER/DEVICE

PORTS port on the Interface Manager card (bottom card in the card

cage).

• Plug an FC cable (not included) into the FC0 port on the interface

controller (middle card) and into either the host bus adapter (HBA)

port on a host or into an FC switch that is connected to the host.

• LTO3 tape drives only: If a second host is available, plug an FC cable

(not included) into the FC1 port on the interface controller (middle

card) and into the HBA port on the host or into an FC switch.

• Plug an Ethernet cable (included) into the CASCADE port on the In-

terface Manager card (bottom card) and into the PUBLIC port on the

library robotics controller (top card in the card cage).

• Plug an Ethernet cable (not included) into the NETWORK port on the

Interface Manager card (bottom card) and into the Ethernet port on

your management station.

Page 8

1 2 3 4 5 6 7 8 9 10 11

Comentários a estes Manuais

Sem comentários

HP EML Base Library Guia de Início Rápido Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Redes HP EML Base Library