HP EML Base Library Guia de Início Rápido descarregar pdf (Página 7)

1. Attach the brackets to the switch.

2. Connect the power cable to the power socket on the back of the

switch.

3. At the rear of the library, install two clip nuts in the center hole of

the 1U location above the robotics unit.

4. Insert the switch into the library. Attach the switch to the rack with

the screws.

5. Route the power cable and plug it into a power strip.

11 Install the tape drives

NOTE:

HP recommends that you install tape drives from top to bottom

with no gaps between them.

At the rear of the library, insert a tape drive into an empty drive bay.

Tighten the thumbscrew to attach the tape drive to the drive bay. Repeat

for each tape drive.

NOTE:

Your library might look different.

12 Install the cable management features

1. Attach the two cable management features with T-25 Torx screws.

Page 7

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

HP EML Base Library Guia de Início Rápido Página 7