HP X Unified Security Platform Series Guia do Utilizador descarregar pdf (Página 26)

Chapter 1. X Family Startup Configuration

18 X Family CLI Reference V 2.5.1

Line Speed

The line speed setting for port. A valid entry will meet the following criterion:

• either 10 or 100

Duplex Setting

The duplex setting for the port. A valid entry must be one of the following:

• copper - full or half

Auto Negotiation

The auto negotiation setting determines whether the port will negotiate its speed based on the

connection it can make. A valid entry must be one of the following:

•on

•off

Example

An excerpt of the Ethernet Port Options dialog follows:

device18# setup eth

Configure slot 3 (Ethernet Ports)? <Y,[N]>:y

Configure port 1 (Ethernet Port)? <Y,[N]>:y

This port is currently enabled, would you like to disable it?

<Y,[N]>:n

Please enter values for the following options

Line speed [100]:

Duplex setting [Full]:

Auto negotiation [On]:

The settings entered for slot 3, port 1 are as follows:

Line speed: 100

Duplex setting: Full

Auto negotiation: On

Enter [A]ccept, [C]hange, or [E]xit without saving [C]: a

Configure port 2 (Ethernet Port)? <Y,[N]>:

Default Email Contact Information

The Default Alert options dialog does not run in the Out-of-the-Box Setup Wizard. You can only access

the Management Port Routing options by using the

setup

command in the CLI.

These options enable you to establish the default sender and recipient for filter alert e-mails.

CAUTION: When you configure a Ethernet port using the command line interface, the port

will be shut down. Use the

conf t int ethernet <slot> <port> no

shutdown

command to restart the port.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 141 142

Sem comentários

HP X Unified Security Platform Series Guia do Utilizador Página 26