HP HP ProCurve Series 6600 Especificações descarregar pdf (Página 40)

2-16

Installing the Switch

Installation Procedures

Installing the Switch

6. Secure the switch to the rack.

Use two 10-32 screws (one for each bracket) to tighten the plenum and

mounting bracket (in a power-side mounting) or only the bracket (in a

port-side mounting) to the rack.

Figure 2-12. Securing a 6600 Switch to the Rack

Mounting a 6600 Switch in an HP 10000 Series Cabinet

6600 Switches can also be mounted in an HP 10000 Series cabinet using the

HP 10000 Series Cabinet: Rack Mount Kit (5070-0145).

To mount a 6600 Switch with this rack mount kit, follow the procedure below.

Refer to the HP 10000 Series Cabinet: Rack Mount Kit Installation Instruc-

tions for additional information.

1. Determine the height at which you want to mount the switch in the rack,

and whether the switch ports will face the hot-aisle or the cold-aisle side

of an equipment cabinet. Unpack the contents of the Rack Mount Kit

(5070-0145) required for your HP 10000 Series 4-post mounting.

HP 10000

Series Notes

When you mount a 6600 switch in an HP 10000 Series cabinet rack, remember

that if the switch ports face in the same direction as the network ports on the

servers, you may have to wrap the power cord over the top of the switch to

reach the opposite side of the rack where the power source is.

Use the clips and screws that are shipped with the cabinet in place of the 12-

24 screws that are shipped with the switch. After you determine the height at

which you want to mount the switch in the cabinet, install the four clips in the

appropriate post holes.

Port-side mounting for a 6600 Switch (Option 3)

Power-side mounting for a 6600 Switch (Option 1 or 2)

Install and tighten a 10-32 screw in the

middle hole.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 115 116

Sem comentários

HP HP ProCurve Series 6600 Especificações Página 40