HP HP ProCurve Series 6600 Especificações descarregar pdf (Página 50)

2-26

Installing the Switch

Installation Procedures

Installing the Switch

■ SFP transceivers are supported in the following slots on 6600 Switches:

• 6600-24G and 6600-24G-4XG: Slots 21S, 22S, 23S, and 24S

• 6600-48G: Slots 45S, 46S, 47S, and 48S

• 6600-24XG and 6600-48G-4XG Switches do not support SFP trans-

ceivers.

■ SFP+ transceivers are supported in the following slots on 6600 Switches:

• 6600-24XG: All slots (1 to 24)

• 6600-24G-4XG: Slots 25, 26, 27, and 28

• 6600-48G-4XG: Slots 49, 50, 51, and 52

• 6600-24G and 6600-48G Switches do not support SFP+ transceivers.

After you install a transceiver, if the switch recognizes the transceiver, the

Mode LED turns on solid for 2 seconds and then goes to normal operation.

Transceiver

Usage Notes

After you insert an SFP or SFP+ transceiver, do not remove the transceiver

until the Mode LED turns off.

If you insert a faulty or non-ProCurve transceiver, the Fault LED and Link LED

of the affected port displays a slow flash for situations that cannot be fixed by

the customer.

If you insert a transceiver that is functional but not supported (such as an SFP

transceiver in an SFP+ slot or an SFP+ transceiver in an SFP slot), the Link

LED of the affected port displays an orange fast flash. Event log messages are

generated. For example, this error condition occurs when an inserted trans-

ceiver is not supported by the switch software, is the wrong revision, or is the

wrong transceiver type.

Removing a Transceiver

Important Be sure to disconnect the network cable from a transceiver before you remove

the transceiver from the switch.

An HP ProCurve transceiver may have any of the following release mecha-

nisms:

■ A plastic tab on the bottom of the transceiver

■ A plastic collar around the transceiver

■ A wire bail

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 115 116

Sem comentários

HP HP ProCurve Series 6600 Especificações Página 50