
HP Integrity rx2620 Upgrade
System Hardware Component Upgrade Instructions
Chapter 1
19
LAN Requirements
The LAN paths for the right and left LAN ports on the rear panel will change as a result of installing this
upgrade. Refer to your OS manual to modify your LAN configuration.
HP Integrity rx2600 LAN path configuration before upgrade:
LAN 10/100 (right) – 0/0/3/0 0x00306E38594B 0 UP lan0 snap0 1 ETHER Yes 119
LAN 10/100/1000 (left) – 0/1/2/0 0x00306E38D9B9 1 UP lan1 snap1 2 ETHER Yes 119
HP Integrity rx2620 LAN path configuration after upgrade:
LAN 10/100/1000 (right) – 0/1/2/0 0x000E7F7E101C 1 UP lan1 snap1 1 ETHER Yes 119
LAN 10/100/1000 (left) – 0/1/2/1 0x000E7F7E101D 2 UP lan2 snap2 2 ETHER Yes 119
NOTE Use the appropriate operating system tool (for example, ifconfig for HP-UX) to validate your
LAN configuration.
Back Up Your System
Before performing the server upgrade, protect yourself by backing up all data and your server OS. In the
event of interruptions (for example power failure or interference), it may be necessary to resume operation in
the old configuration before upgrading the server.
Back Up Your Data
Back up your data in accordance with local procedures.
Back Up the Operating System
Always keep a backup copy of the current operating system (OS) available for emergency use. The OS was
provided on CD with your server.
System Shutdown
Step 1. Press the power switch on the server front panel. Verify that the power LED goes off.
Step 2. Disconnect the AC power cords from the server rear panel.
System Hardware Component Upgrade Instructions
This section contains detailed instructions for upgrading the rx2600 or rp34x0 to an rx2620 using the
following procedure:
Step 1. Remove system top metal cover and bezel.
Step 2. Remove system fans, PCI card cage, airflow guides, memory, processors, management processor
and system board.
Step 3. Upgrade system board.
Comentários a estes Manuais