HP Integrity rx2600 Informações Técnicas descarregar pdf (Página 55)

HP Integrity rx2620 Upgrade

System Hardware Component Upgrade Instructions

Chapter 1

Reinstalling PCI Card Cage

To reinstall the original PCI cage, perform the following action:

Step 1. Insert the PCI card cage into the system and engage the release lever.

Reinstalling System Fans 2 and 3

NOTE System fans 1A and 1B must be upgraded. See “Upgrade CPU Fans (1A and 1B)”.

Step 1. Grasp the fan module and insert it into its fan socket.

Step 2. Check for proper seating of the fan in its socket.

Upgrade CPU Fans (1A and 1B)

Step 1. Verify that fans 1A and 1B (AB331-04001) are those provided with the upgrade kit before

installation.

Step 2. Grasp the fan module and insert it into its fan socket.

Step 3. Check for proper seating of the fan in its socket.

Step 4. Insert the two airflow guide retaining tabs into the two slots on the front half of the airflow guide.

Installing HP Integrity rx2620 Name Plate and Intel Itanium 2 Rack Label

To install the HP Integrity rx2620 server name plate and Intel Itanium 2 rack label, follow these steps:

Step 1. Locate the name plate release prongs on the back side of the system bezel.

Step 2. Exert outward pressure on the prongs until the name plate releases through the front of the bezel.

Step 3. Push on the new name plate through the front of the bezel until it snaps into place.

Step 4. If upgrading from rp34x0, affix Intel Itanium 2 label to outside of rack and adjacent to the server.

Apply UUID Label (rp34x0)

When upgrading from an rp34x0, apply the UUID label to the rear of the pull tab located in the slot between

the power supply and disk drives.

NOTE The UUID label is not used when upgrading from an rx2600 and should be discarded.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 68 69

Sem comentários

HP Integrity rx2600 Informações Técnicas Página 55