HP DesignJet ColorPro CAD Manual do Utilizador descarregar pdf (Página 252)

Removal and Replacement of Parts (with Calibration)10-34

Replacement of Parts

Replacement of Print Carriage Flex Cable

You will be removing the print carriage flex cable from the printer and installing a new flex cable.

Removing the Print Carriage Flex Cable

Step 1. Remove the Sensor Housing Assembly

(refer to the procedures in Removing

the Sensor Housing Assembly from

Replacement of Sensor Assembly

Housing).

Step 2. Remove the stopper shaft on the left of

the carriage chassis assembly by turning

it anticlockwise until it is inverted and

can be removed.

Step 3. Remove the stopper shaft on the right in

a similar manner, turning it clockwise.

Step 4. Remove the stopper spring.

Step 5. Remove the encoder strip by gently

pulling it to the left until the left end can

be unhooked, then unhook the right end

from the encoder snub and carefully

slide the encoder strip free.

Step 6. Slacken tension in the drive belt by

pushing inwards on the idler assembly

till the belt comes loose.

Step 7. Remove the flex clamp by unlatching

the retaining tabs from underneath.

Step 8. Slide the carriage shaft out and separate

the print carriage from the rest of the

other components.

www.GovTechMedia.com

1 2 ... 247 248 249 250 251 252 253 254 255 256 257 ... 261 262

Sem comentários

HP DesignJet ColorPro CAD Manual do Utilizador Página 252