
2. Remove the four sliver screws (A and B in the following figure) that secure the lamp housing to
the lower lamp assembly.
Figure 9-3 User end screws
B
A
A
B
3. LIft up to remove the lamp housing from the printer.
Remove the service-end lamp housing
1. Disconnect the auxiliary cable from the top of the service-end lamp. See Figure 9-1 Disconnect
the user-end auxiliary cable on page 60 for location.
2. Remove the lamp power cable from the side of the lamp housing by turning the coupling
counterclockwise. See
Figure 9-2 Remove the user-end power cable on page 60 for location.
ENWW Replace UV lamp bulb (500–1000 hours) 61
Comentários a estes Manuais