HP FB500 Manual do Utilizador descarregar pdf (Página 71)

3. Install the spring-loaded clamp’s dowels (A and B below) into the reflector.

Figure 9-9 Installing the dowels into the reflector

4. Repeat this procedure for the other lamp.

Re-install the lamp housings

Re-install the user-end lamp housing

1. Secure the lamp housing to the lamp assembly using the original two lower silver screws on the

user end of the carriage (see screws A in

Figure 9-3 User end screws on page 61 for locations).

●

If you have difficultly fitting the lamp housing back onto the lamp base, loosen the four

screws indicated below.

●

If the lamp housing is still difficult to install, squeeze the side of the lamp base to bend the

side in about 0.8 mm (0.031 in).

Figure 9-10 Loosening screws to ease installation

ENWW Replace UV lamp bulb (500–1000 hours) 65

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 101 102

Sem comentários

HP FB500 Manual do Utilizador Página 71