HP Ink Tank 310 Manual do Utilizador descarregar pdf (Página 51)

Tips for working with ink and printhead

Printhead tips

Use the following tips to work with printheads:

● To protect the printheads from drying out, always turn the printer o using the Power button, and wait

until the Power button light goes out.

● Do not open or untape printheads until you are ready to install them. Leaving tape on the printheads

reduces ink evaporation.

● Insert the new printheads into the correct slots. Match the color and icon of each printhead to the color

and icon for each slot. Make sure the printheads snap into place, and then close the printhead latch.

After you have set up the printer, do not open the printhead latch unless installing new printheads or

moving the printer outside your home or oice.

● Align the printer for best print quality. See Printing issues on page 62 for more information.

Ink tips

Use the following tips to work with ink:

● Make sure the ink tanks are lled with ink and the ink levels are above the minimum line before printing.

● Rell the ink tanks when the ink level reaches the minimum line. Printing with the ink level below the

minimum line may cause damage to your printer.

● Do not make the ink level be above the maximum line by overlling the ink tanks or tilting the printer.

The ink level higher than the maximum line can cause ink leaks and ink mixing.

46 Chapter 5 Manage ink and printhead ENWW

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 97 98

Sem comentários

HP Ink Tank 310 Manual do Utilizador Página 51