HP SN6000 Manual do Utilizador descarregar pdf (Página 65)

HP SAN Connection Manager User Guide 65

2. Under IPsec Associations, click Create.

The IPsec Association dialog box opens (Figure 40). You must complete all fields prefaced by a red

asterisk.

NOTE: SAN Connection Manager allows you to create a maximum of 512 IPsec associations.

Figure 40 IPsec Association dialog box

3. Complete the IPsec Association dialog box as follows:

Name Enter a unique alphanumeric name that starts with a letter, does not contain

spaces, and does not exceed 32 characters. You may include the following

special characters: ampersand (&), hyphen (-), circumflex (^), and underscore

(_).

Description (Optional) Enter a description of the IPsec policy.

Source Address Enter either a valid IPv4 address, a valid IPv6 address, or a valid DNS host

name.

Destination Address Enter either a valid IPv4 address, a valid IPv6 address, or a valid DNS host

name of the host, switch, or gateway from which data originates.

Protocol Select one of the following IP security protocols to be used to process data:

• ESP—Encapsulating Security Payload based on RFC 2405: The ESP

DES-CBC Cipher Algorithm With Explicit IV (November 1998).

• ESP-old—Encapsulating Security Payload based on RFC 1827: IP

Encapsulating Security Payload (ESP) (August 1995)

• AH—Authentication Header based on RFC 2402: IP Authentication Header

(November 1998)

• AH-old—Authentication Header based on RFC 1826: IP Authentication

Header (August 1995)

If you select ESP or ESP-old, you must also select the Encryption method and

enter an Encryption Key.

SPI Enter a SPI number in the range of 256 to 4294967295.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 161 162

Sem comentários

HP SN6000 Manual do Utilizador Página 65