HP SN6000 Manual do Utilizador descarregar pdf (Página 15)

HP SAN Connection Manager User Guide 15

13. When you restart your computer, the system may report finding new hardware. If so, respond to these

messages by clicking Cancel.

Figure 4 Installation wizard: Enable VCEM Server Enclosure Discovery

Repeat this procedure to install the software on additional Windows servers.

Linux installation: initial

Follow these steps to install the required software on servers running Linux.

NOTE: To configure servers using other operating systems or non-QLogic HBAs, see “Configuring SAN

Connection Manager for HP-UX and Emulex HBAs,” page 17.

To install the components required by SAN Connection Manager on Linux:

1. Insert the installation CD into the CD-ROM drive of the server.

The installation CD should mount automatically in one of the following locations:

/media/cdrom/

/mnt/cdrom/

/media/cdrecorder/

If the installation CD is not mounted automatically, issue the following commands to mount the CD:

# mkdir -p /mnt/cdrom

# mount /dev/cdrom /mnt/cdrom

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 161 162

Sem comentários

HP SN6000 Manual do Utilizador Página 15