HP SN6000 Manual do Utilizador descarregar pdf (Página 40)

40 Getting Started

Drive Operations:

•Click Manage Hot Spare Drive to set or remove a drive as a hot spare from the Manage Storage

Subsystem dialog box (see “Managing storage subsystems,” page 122).

•Click Blink Drive LED to flash a drive’s LED from the Manage Storage Subsystem dialog box (see

“Managing storage subsystems,” page 122).

Switch Operations:

•Click Set Switch IP Address to open the Set Switch IP Address dialog box (see “Setting the switch

IP address,” page 54).

•Click Update Switch Firmware to open the Switch Firmware Update wizard (see “Updating

switch firmware,” page 56).

HBA Operations:

•Click Update HBA BIOS to open the Update HBA BIOS wizard (see “Updating an HBA BIOS

image,” page 76).

•Click Update HBA Driver to open the HBA Driver Update wizard (see “Updating an HBA driver,”

page 78).

16. To exit this dialog box without performing any configuration, and view the SAN Connection Manager

main window, click Close. (All configuration options offered on this dialog box are also available from

the main window.)

17. A dialog box indicates when the last refresh of the SAN components was performed. Click OK.

Figure 21 Last Refresh of SAN Components dialog box

Now that you have completed the initial switch setup and other common configuration operations, you can

use SAN Connection Manager to configure your SAN, as described in the remainder of this guide.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 161 162

Sem comentários

HP SN6000 Manual do Utilizador Página 40