HP Switch 6120 Manual do Utilizador descarregar pdf (Página 329)

100

101

9-19

Traffic/Security Filters and Monitors

Configuring Traffic/Security Filters

Figure 9-14. Assigning Additional Destination Ports to an Existing Filter

For example, suppose you wanted to configure the filters in table 9-2 on a

switch. (For more on source-port filters, refer to “Configuring a Source-Port

Traffic Filter” on page 9-16.)

Table 9-2. Filter Example

The following commands configure the filters listed above:

Figure 9-15. Configuring Various Traffic/Security Filters

Filter Indexing

The switch automatically assigns each new filter to the lowest-available index

(IDX) number. The index numbers are included in the show filter command

described in the next section and are used with the show filter < index >

command to display detailed information about a specific filter.

If there are no filters currently configured, and you create three filters in

succession, they will have index numbers 1 - 3. However, if you then delete

the filter using index number “2” and then configure two new filters, the first

Filter Type Filter Value Action Destination Ports

Source-Port Inbound ports: A1, A2* Drop D1-D4

*Because the switch allows one inbound port in a source-port filter, the

requirement to filter ports A1 and A2 means you will configure two

separate source-port filters.

1 2 ... 324 325 326 327 328 329 330 331 332 333 334 ... 468 469

Comentários a estes Manuais

Sem comentários

HP Switch 6120 Manual do Utilizador Página 329

Comentários a estes Manuais

Manuais e produtos relacionados com Software HP Switch 6120