HP Switch 6208M-SX Manual do Utilizador descarregar pdf (Página 115)

100

101

Installation and Getting Started Guide

Table 5.4: Web Management Display of STP Information

This Field... Displays...

STP Bridge Parameters (global parameters)

VLAN ID The port-based VLAN that contains this spanning tree (instance of

STP). AN 1 is the default VLAN. If you have not configured port-

based VLANs on this device, all STP information is for VLAN 1.

Root ID The ID assigned by STP to the root bridge for this spanning tree.

Root Cost The cumulative cost from this bridge to the root bridge. If this device

is the root bridge, then the root cost is 0.

Root Port The port on this device that connects to the root bridge. If this device

is the root bridge, then the value is “Root” instead of a port number.

Priority This device or VLAN’s STP priority. e value is shown in

hexadecimal format.

Note: If you configure this value, specify it in decimal format. See

“Changing STP Bridge Parameters” on page 5-4.

Max Age The number of seconds this device or VLAN waits for a hello message

from the root bridge before deciding the root has become unavailable

and performing a reconvergence.

Hello Time The interval between each configuration BPDU sent by the root

bridge.

Hold Time The minimum number of seconds that must elapse between

transmissions of consecutive Configuration BPDUs on a port.

Forward Delay The number of seconds this device or VLAN waits following a

topology change and consequent reconvergence.

Topology Last Change The number of seconds since the last time a topology change

occurred.

Topology Change Counter The number of times the topology has changed since this device was

reloaded.

Bridge Address The STP address of this device or VLAN.

Note: If this address is the same as the Root ID, then this device or

VLAN is the root bridge for its spanning tree.

STP Port Parameters

VLAN The VLAN that the port is in.

Port The port number.

Priority The port’s STP priority, in hexadecimal format.

Note: If you configure this value, specify it in decimal format. See

“Changing STP Port Parameters” on page 5-5.

Path Cost The port’s STP path cost.

5 - 10

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 709 710

Comentários a estes Manuais

Sem comentários

HP Switch 6208M-SX Manual do Utilizador Página 115

Comentários a estes Manuais

Manuais e produtos relacionados com Software HP Switch 6208M-SX