HP 20-Feb Manual do Utilizador descarregar pdf (Página 106)

104 Configuring the Library for Fibre Channel Chapter 3

7. P re s s [OK] when complete to save the changes, or select [QUIT] to return to

the beginning of the fibre configuration menu. If you select

[QUIT], a

message will display indicating the old values will be retained.

If you select [OK], a message will display indicating that the settings are

being stored onto the Fibre Channel controller. If this is successful, a

message displays indicating that the new settings will be attempted at the

next restart.

8. To immediately apply the new settings, select [RESTART], or select [DONE] to

wait until the next power cycle.

When the Fibre Channel controller is restarted, or when the library is

power-cycled,

FUTURE SETTINGS are copied into CURRENT SETTINGS. The

Fibre Channel controller always attempts to connect using

CURRENT

SETTINGS

If you select [RESTART], the Fibre Channel controller is restarted. This should

not be attempted if data transfers or library operations are in progress.

The

[RESTART] operation normally completes within 90 seconds. The

display will report the status of the operation when it is complete.

Note The actual connection achieved depends on the external

topology and network. Consequently,

CURRENT STATUS may

differ from CURRENT SETTINGS.

Note You can also change configuration from remote access. See

Using the Remote Management Card on page 96.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 237 238

Sem comentários

HP 20-Feb Manual do Utilizador Página 106