HP 20-Feb Manual do Utilizador descarregar pdf (Página 165)

Chapter 5 Removing and Replacing Drive Modules 163

Chapter 5

Removing a Drive Module

Note To preserve SCSI communications, do not loosen or remove the

SCSI cable(s) connected to the outside of the drive module. The

connection to be removed is located inside the drive module.

Remove the drive module using the steps below:

1. Verify the external SCSI cable is tightened to the connector plate.

2. Loosen the thumbscrews on each side of the connector plate, located in the

middle of the drive module (Figure 51 on page 163). If this is your first

time loosening the thumbscrews, use a screwdriver.

3. Gently remove the connector plate, with SCSI cable(s) still connected.

Caution Use standard precautions for electro-static discharge (ESD)

protection.

4. Grasp the ribbon cable that is plugged into the drive module. Remove the

cable by pulling the connector to the left. See Figure 51 on page 163 for

the location of the ribbon cable and connector.

Figure 51 Ribbon Cable and Connector

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 237 238

Sem comentários

HP 20-Feb Manual do Utilizador Página 165