
Korean notices
Safety
Batter y repl
acement notice
Your switch i
s equipped with a lithium manganese dioxide, a vanadium pentoxide, or an alkaline internal
battery or b
attery pack. There is a danger of explosion and risk of personal injury if the battery is
incorrectly replaced or mistreated. Replacement is to be done by an HP authorized ser vice provider using
the H P spare pa rt designated for this product. For more information about battery replacement or proper
disposal, contact an HP authorized ser vice provider.
WARNING!
Your switc
h contains an internal lithium manganese dioxide, a vanadium pentoxide, or an alkaline
battery pa
ck. There is risk of fire and burns if the battery pack is not properly handled. To reduce the
risk of personal injury:
• Do not attempt to recharge the battery.
• Do not exp
ose to temperatures higher than 60 ºC (140 ºF).
• Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.
• Replace only with the HP spa re pa rt designated for this product.
Batteries, battery packs, and accumulators should not be disposed of together with the general household
waste. To forward them to recycling or proper disposal, please use the public collection system or return
them to HP, an authorized HP Partner, or their agents.
For m ore information about battery replacement or proper disposal, contact an HP authorized reseller or
service provider.
Taiwan battery recycling notice
The Taiwan EPA requires dry battery manufacturing or importing firms in accordance with Article 15
of the Waste Disposal Act to indicate the recovery marks on the batteries used in sales, giveaway, or
promotion. Contact a qualified Taiwanese recycler for proper batter y disposal.
Power cords
The power cord set must meet the requirements for use in the country where the product was purchased.
If the product is to be used in another country, purchase a power cord that is approved for use in
that country.
The power cord must be rated for the product and for the voltage and current marked on the product
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and
current rating m arked on the product. In addition, the diameter of the wire must be a minimum of 1.00
220
Regulatory compliance and safety
Comentários a estes Manuais