Hp Integrity rx4610 Server Manual do Utilizador descarregar pdf (Página 37)

Chapter 4 Installing Mass Storage Devices

NOTE The boot order can be changed using the Server's (BIOS) Setup

Utility and the Qlogic SCSI Utility. Refer to Chapter 10,

"Configuring the HP Server" for more information.

Tools Required

The following tools are required for the removal and installation of mass storage

devices in the HP Server:

• Phillips (cross-head) screwdriver (#2).

• Small flat-bladed screwdriver.

• Jumper-removal tool or needle-nosed pliers.

• Antistatic wrist strap and conductive foam pad (recommended).

• Pen or pencil.

• Equipment log: to record the model and serial numbers of components.

Installing a Hot Swap Hard Drive

The HP Server supports a variety of single-ended SCSI SCA-type hard disk

drives. The area of the chassis below the system’s controls and indicators on the

front panel houses up to two 3.5-inch bays. Each bay can contain a single

industry-standard SCSI-2 or SCSI-3, one-inch high hard disk drive from the

factory. The procedures in this section describe how to determine drive status,

remove a faulty drive, and install a new drive.

Determining Drive Status

Status LEDs arranged in sets of three over each of the two Hard Disk Bays

monitor the status of each drive.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 248 249

Sem comentários

Hp Integrity rx4610 Server Manual do Utilizador Página 37