Hp Integrity rx4610 Server Manual do Utilizador descarregar pdf (Página 54)

Chapter 5 Installing Additional Memory

4. Loosen the two captive screws holding the sides of the memory board to

the processor board. Each of these screws secures a board clamp that runs

along the length of the memory board.

5. Lift the board clamps out of the Processor/Memory Complex.

6. Loosen the two captive screws in the handle that spans the middle of the

Memory Board.

7. Remove the bracket with the thumbscrew that locks the extraction levers.

8. Pull up on the extraction levers to disengage the memory board from the

processor board.

NOTE Both extraction levers must be raised evenly while disengaging

the memory from the Processor Baseboard. The memory board

must remain parallel to the Processor Baseboard during

extraction.

9. Place the memory board on a clean ESD-protected surface.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 248 249

Sem comentários

Hp Integrity rx4610 Server Manual do Utilizador Página 54