© Copyright 2013 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for
HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as
constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.
May 2013
Q I have a contour cutter, does the included basic RIP support these cutter marks
The SAi Felxiprint HP Basic Edition does not include the cutter marks. Customers have the option to upgrade to the SAI
Premium version which supports contour cutting. Alternatively Graphtec or Summa offer cutter plug-ins for Adobe
Illustrator to insert cutter marks.
Maintenance, diagnostics, service & support
Q Is there a daily maintenance routine that needs to be run before printing, and if so
how long does it take?
No. There is no daily routine maintenance. The maintenance routine will be automatically adjusted depending on how long
has been the printer idle. If the printer is not used more than once per week, printhead servicing will take between 30
seconds to 1.5 minutes. Before a print job the printer checks for nozzle health and depending on the result the printer may
need to perform additional auto recovery which is 1.9 min.
Q How much ink is used during servicing?
If the printheads are in a reasonable condition servicing will use a very minimal amount of ink. The worst case scenario
would range from 0.064g to a maximum of 0.980g per affected color.
Q How long does the HP 831 Latex Maintenance Cartridge last?
Based on average operating conditions the maintenance cartridge should last for up to14 litres of ink consumed. This
ranges between 2.9 litres to 3.6 litres per month, meaning that the cartridge needs to replace every 3 to 5 months based on
average usage.
Q What are the service intervals for the latex 300 family? How often does a service
technician need to visit or can it be done ourselves?
Approximately every 110 liters there’s a service visit. Depending on the total usage and subsystem cycles, the intervention
requires different service maintenance kits that can occur every 12 to 18 months and should take the technician 2.5 hours
to complete.
There is one service routine that is carried out by the user which involves a simple lubrication task of the carriage rod every
300 000 scan axis cycles. Based on a usage of 500sqm per month this would occur once every 4 months.
Then there is three different service intervals carried out by technicians:
SMK3 every 110 liters or 3000 Km of scan axis (based on 500 sqm/month it would occur every 1.5 years)
SMK1 every 4 million scan axis cycles (based on 500 sqm/month it would occur every 5 years)
SMK2 every 3 million service station cycles (based on 500 sqm/month it would occur every 7 years)
Q Will HP or partners be offering an end of installation training or a ramp up
training and if so what will be covered?
Yes. One day is to be used for installation and operator training by the reseller to ensure that the end user is comfortable
operation of the printer.
(2 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais