HP rp5400 Guia de Instalação descarregar pdf (Página 16)

Installing Additional Components

Installing Peripheral Component Interconnect (PCI) Cards

Chapter 1

Installing Peripheral Component Interconnect (PCI) Cards

rp54xx Servers have a total of 12 PCI I/O slots. Slots 1 and 2 are reserved for the LAN/SCSI and GSP Core I/O

cards, leaving 10 PCI I/O slots available for twin use.

rp5400/rp5450 PCI Card Slots

For rp5400 and rp5450 models, 10 PCI I/O slots consist of turbo and non-turbo slots. Server PCI slots are

shown below.

• Slots 1 and 2 are reserved for the rp54xx LAN/SCSI and GSP (Guardian Service Processor) Core I/O

cards, respectively. Slots 1 and 2 are non-turbo slots. Non-turbo slots share a single 250MB/s PCI bus and

are incapable of hot-plug functionality. The server must be turned off prior to removing or installing the

LAN/SCSI or GSP cards in these slots.

• Slots 3 - 6 are non-turbo slots. These four Non-turbo slots share a single 250MB/s PCI bus, run at 33MHz

and support 32 and 64-bit PCI cards. Non-turbo slots are incapable of hot-plug functionality. The server

must be turned off prior to removing or installing PCI cards in these slots.

• Slots 7 - 12 are turbo slots. Each turbo slot has a dedicated 250MB/s PCI bus, run at 66MHz and support

32 and 64-bit PCI cards. Turbo slots are hot-plug capable. Below each turbo slot is a plastic PCI card

separator. The PCI card separator has two LEDs and a pull tab on the outer edge. The LED’s provide

power and status for the slot. The pull tab allows the PCI card to be easily removed.

rp5400 Servers have access to slots 1, 2 and 8-12 while rp5450 Servers have access to all (1-12) slots.

NOTE Slot 3 will become enabled on rp5400 Servers with server firmware versions later than 40.48.

A slot 3 enabled label (A5576-84009) is available for rp5400 systems.

rp5400/rp5450 PCI Card Slots

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 83 84

Sem comentários

HP rp5400 Guia de Instalação Página 16