HP rp5400 Guia de Instalação descarregar pdf (Página 47)

Server Unpacking and Installation

Install Stand-Alone Server in a Cabinet

Chapter 2

Step 13. Use six, M5 x 12 screws (without washers) to attach the tray to the slides. Three screws are used to

attach each slide. Insert the screws through the slides, through the tray and tighten into the

threaded nuts located on the inside of the sides of the tray.

Step 14. From the bottom of the tray pull the plunger pin down and give it a 1/4 turn to hold it in place.

Step 15. Position the server on the tray aligning the plunger pins with the alignment holes in the chassis.

Step 16. Release the plunger pins to secure the server.

3 Pan Head

M5x12 T25 screws

on each side

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 83 84

Sem comentários

HP rp5400 Guia de Instalação Página 47