HP rp5400 Guia de Instalação descarregar pdf (Página 46)

Server Unpacking and Installation

Install Stand-Alone Server in a Cabinet

Chapter 2

Step 10. Use an M5 x 30 screw with a cress cup washer to attach the front of the slide to the vertical

mounting post. Insert the screw through the slide, through the center hole of the aluminum spacer,

through the vertical mounting post, and tighten into the sheet metal nut located at that position.

Step 11. Use a procedure similar to steps 7 through 10 to install the right hand slide/bracket assembly

(marked 337079-1R) and then proceed to step 12.

Step 12. Take the tray and place it onto the pins that extend from the slides' inner members. The slots with

wide lead-in guides on the side of the tray fit down onto the slides' pins. The flat part of the tray will

be on top, and the mounting holes in the top of the tray will be located to the right of the center of

the tray. Slide the tray all the way down on both sides so that the pins reach the top of the slots in

the side of the tray.

Pins in Slots

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 83 84

Sem comentários

HP rp5400 Guia de Instalação Página 46