HP rp5400 Guia de Instalação descarregar pdf (Página 75)

Cabling and Power-Up

GSP Configurable Parameters

Chapter 3

CAUTION Be sure to read each prompt carefully and enter the correct response. A missed or incorrect

entry could deny entry to that user.

The following is an example of an added user’s information:

. User’s Name: Joe Smith

. Organization’s Name: IT Support

. Dial-back configuration: Disabled

. Access Level: Operator

. Mode: multiple

. User’s state: enabled

For the number 1 user, the Access level is administrator. The Mode entry of single

only allows entry for that user one time, then access will be denied. A Mode entry of

multiple allows unlimited entries into the GSP.

Removing Users

You can remove (disable) a GSP user with the same Security options and access control (SO) command used to

add a user.

To remove a user, perform the following steps:

1. Access the GSP with the ctrl+b entry.

2. At the GSP prompt, enter the Security options and access control (SO) command:

GSP> so

3. The first prompt you will see with the SO command is for GSP-wide parameters:

GSP wide parameters are:

. Login Timeout: 1 minutes.

. Number of password Faults allowed: 3

. Flow Control Timeout: 5 minutes.

Do you want to modify the GSP wide parameters? (Y / N) __

At this point you can modify the GSP wide parameters, or continue with removing a user. To remove

users, respond N for no.

NOTE You will have to step through each user number until you reach the user to be removed.

4. When you access the number of the user to be removed, you must change the data in the prompts for that

number.

It is important that, at a minimum, you need to modify the User’s state to Disabled.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 83 84

Sem comentários

HP rp5400 Guia de Instalação Página 75