HP rp5400 Guia de Instalação descarregar pdf (Página 20)

Installing Additional Components

Installing Peripheral Component Interconnect (PCI) Cards

Chapter 1

Installing a PCI Card

Follow these procedures to install a PCI card.

Step 1. Power down and unplug the rp54xx Server.

NOTE DC voltages are present when the server is connected to AC power. Do not attempt to

install or service: CPUs, memory, PSMs, the platform monitor or PCI I/O cards

installed in non-turbo slots (1-6) while DC voltage is present. Failure to observe this

warning may result in damage to the server.

Step 2. Make the right side of the server accessible for service.

Step 3. Using a torx 15 screwdriver, loosen the captive screws on the right side panel. This panel has a

label which shows which PCI I/O slots are available and the corresponding paths. The PCI I/O slot

paths for rp5400, rp5450, and rp5470 are shown below.

Slot

rp5400 rp5450 rp5430/rp5470

Slot Type Path Slot/Type Path Slot Type Path

12 Turbo 0/4/0 Turbo 0/4/0 Twin Turbo 0/10/0

11 Turbo 0/7/0 Turbo 0/7/0 Twin Turbo 0/12/0

10 Turbo 0/3/0 Turbo 0/3/0 Turbo 0/8/0

9 Turbo 0/6/0 Turbo 0/6/0 Turbo 0/9/0

8 Turbo 0/2/0 Turbo 0/2/0 Turbo 0/3/0

7 Not Available Turbo 0/5/0

Turbo

0/1/0

6 Not Available Shared 0/1/0

Turbo

0/5/0

5 Not Available Shared 0/1/1

Turbo

0/2/0

4 Not Available Shared 0/1/2

Shared

1. Slot is NOT AVAILABLE for rp5430.

0/4/0

3Not

Available

2. Slot 3 becomes available with server firmware versions later than 40.48.

Shared 0/1/3 Shared 0/4/2

2 GSP GSP GSP

1 LAN/SCSI LAN/SCSI LAN/SCSI

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 83 84

Sem comentários

HP rp5400 Guia de Instalação Página 20