HP 200 Unified Threat Management (UTM) Appliance Series Guia de Início Rápido descarregar pdf (Página 106)

100

• After job execution, the configuration interface, view, and user status that you have before job

execution restores even if the job ran a command to change the user interface (for example, telnet,

ftp, and ssh2), the view (for example, system-view and quit), or the user status (for example, super).

• The jobs run in the background without displaying any messages except log, trap and debugging

messages.

• If you reboot the device, the system time and date are restored to the factory default. To make sure

scheduled jobs can be executed at the expected time, you must change the system time and date or

configure NTP for the device. For NTP configuration, see Network Management and Monitoring

Configuration Guide.

• In the modular approach:

{ Every job can have only one view and up to 10 commands. If you specify multiple views, the

one specified last takes effect.

{ Enter a view name in its complete form. Most commonly used view names include monitor for

user view, system for system view, GigabitEthernet x/x for Ethernet interface view, and

Vlan-interfacex for VLAN interface view.

{ The time ID (time-id) must be unique in a job. If two time and command bindings have the same

time ID, the one configured last takes effect.

Scheduling a job in the non-modular approach

To schedule a job, execute one of the following commands in user view:

Task Command Remarks

Schedule a job.

• Schedule a job to run a command at a specific

time:

schedule job at time [ date ] view view

command

• Schedule a job to run a command after a delay:

schedule job delay time view view command

Use either command.

If you execute the schedule job

command multiple times, the most

recent configuration takes effect.

Changing any clock setting can

cancel the job set by using the

schedule job command.

Scheduling a job in the modular approach

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Create a job and enter

job view.

job job-name N/A

3. Specify the view in which

the commands in the job

run.

view view-name

You can specify only one view for

a job. The job executes all

commands in the specified view.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 149 150

Comentários a estes Manuais

Sem comentários

HP 200 Unified Threat Management (UTM) Appliance Series Guia de Início Rápido Página 106

Comentários a estes Manuais

Manuais e produtos relacionados com Software HP 200 Unified Threat Management (UTM) Appliance Series