Hp Unified Extensible Firmware Interface Manual do Utilizador descarregar pdf (Página 93)

Figure 84 Advanced Options —Virtual Install Disk screen

Setting PCI Bus Padding Options

You can disable the default PCI Bus padding where each expansion slot is provided with an extra

PCI Bus number. By default, the System BIOS pads one PCI bus per expansion slot to allow

expansion cards with PCI-PCI bridges to not effect current bus numbering schemes. Disabling this

option works around issues with certain expansion cards. It is not recommended to disable this

option unless a specific issue is encountered.

HP recommends disabling this option only when encountering a specific issue.

To set PCI Bus padding options:

1. From the System Utilities screen, select System Configuration→BIOS/Platform Configuration

(RBSU)→Advanced Options→Advanced System ROM Options→PCI Bus Padding Options and

press Enter.

2. Select one of the following options:

• Enabled (default)

• Disabled

3. Press F10 to save your selection.

Accessing the BIOS/Platform Configuration (RBSU) menu 93

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 157 158

Sem comentários

Hp Unified Extensible Firmware Interface Manual do Utilizador Página 93