Hp StoreEver TapeAssure Software Manual do Utilizador descarregar pdf (Página 179)

(Linux)

1. Fully install L&TT onto a computer. If desired, also install any necessary firmware files into the

firmware subdirectory.

2. Remove the logs directory from the L&TT install directory.

3. Write the contents of the L&TT install directory (/opt/ltt) to the root directory of a CD or

USB flash drive. Close the CD.

4. Insert the CD or USB flash drive into any Linux system and mount the CD or USB flash drive.

From the mount path run hp_ltt as you would on any other Linux system.

When L&TT is run from a CD, USB flash drive, or remote directory, L&TT will prompt you for the

directory where the temporary files and reports will be placed, as shown in Figure 80 (page 179)

and Figure 81 (page 179). This directory can be removed once L&TT is stopped.

Figure 80 Prompt for temporary file directory (Windows)

Figure 81 Prompt for temporary file directory (Linux)

Running L&TT from a shared directory

You can run L&TT from a shared network directory. This approach is most useful when running

L&TT on a computer that already has shared directory access to another computer.

To install L&TT on a computer in preparation for running it remotely from another computer:

• Fully install L&TT onto a computer in a directory that will be accessible to other computers. If

desired, also install any necessary firmware files into the firmware subdirectory.

(Windows) To run L&TT from a remote directory:

Running L&TT from computers without L&TT installed 179

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 212 213

Sem comentários

Hp StoreEver TapeAssure Software Manual do Utilizador Página 179