HP AG321A Guia de Início Rápido descarregar pdf (Página 11)

Place the protected Extender in the shipping box.

Secure the box with packaging tape.

Replacing the Extender

To replace the Extender, continue with Step 13 on page 6 in the Getting

started guide section of this document.

4 Preparing the Libraries to operate as

separate Libraries

Follow the steps in the remainder of this document if you are

reconfiguring the extended library into two separate Libraries.

Relocating tape drives

Each Library must have at least one tape drive. Skip this step if you do

not need to relocate a tape drive from one Library to the other.

IMPORTANT:

To avoid damage to the Library, ensure that the tape drive is

powered off before removing it from a Library.

To remove a tape drive from its current location, loosen the blue captive

thumbscrews on the tape drive.

Pull straight back on the tape drive handle while supporting the bottom

of the tape drive to remove it from the Library.

If necessary, remove one or two drive bay covers.

Slide the tape drive into its new drive bay. Tighten the blue thumbscrews

with your fingers to secure the tape drive in the Library.

Replacing drive bay covers

Use a #1 Phillips screwdriver to secure drive bay covers over any open

tape drive bays.

Page 11

1 2 ... 6 7 8 9 10 11 12

Sem comentários

HP AG321A Guia de Início Rápido Página 11