HP AG321A Guia de Início Rápido descarregar pdf (Página 4)

Obtain adequate assistance to lift and stabilize the Library during

removal and replacement.

From the front of the Library 1) completely loosen the screws inside the

left and right front bezel (these are captive screws and cannot be

removed), then 2) slide the Library out of the rack or cover using

assistance.

CAUTION:

Lift the Library from the side edges. Lifting the Library from the

magazine or drive openings, or from the drive handles can

damage the Library.

Moving the rack rails and clip nuts

Using a #3 Phillips screwdriver, remove the rails from the rack. For an

MSL4048 or MSL8096 also remove the clip nuts.

Secure one rail to each side of the rack in the new location. Secure the

front and the back of each rail to the rack. The front of the rails is straight

and the back is angled.

Moving the clip nuts

MSL8096MSL4048

2. Rail screw location1. Clip nut location

4. U marker3. Library bottom

For the MSL4048 and MSL8096, replace the clip nuts in the locations

shown.

Installing the Library in the rack rails

11405

With assistance, slide the Library onto the metal rails. Secure the front

bezel to the rack using a #2 Phillips screwdriver placed through the

small holes in the mounting bracket to tighten the captive screws on each

side of the Library.

Replace tape cartridges and magazines in the Library.

Page 4

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

HP AG321A Guia de Início Rápido Página 4