HP AG321A Guia de Início Rápido descarregar pdf (Página 5)

10 Relocating tape drives

The extender is installed in the bottom half-height drive bay of the upper

Library and the top half-height drive bay in the lower Library. If a tape

drive is installed in either of these drive bays, relocate the tape drive to

another drive bay.

Verify that the Library is powered off.

To remove a tape drive from its current location, loosen the blue captive

thumbscrews on the tape drive.

Pull straight back on the tape drive handle while supporting the bottom

of the tape drive to remove it from the Library.

If necessary, remove one or two drive bay covers from the destination

drive bay.

Slide the tape drive into its new drive bay. Tighten the blue thumbscrews

with your fingers to secure the tape drive in the Library.

If you removed a tape drive and are not reinstalling it in a Library, store

it in an anti-static bag.

11 Removing and replacing drive bay

covers

If necessary, use a #1 Phillips screwdriver to remove the bottom

half-height drive bay cover from the upper Library and the top half-height

drive bay cover from the lower Library to create a space for the Library

Extender.

Install drive bay covers over any drive bays that are not used by a tape

drive or the Library Extender. Two half-height drive bay covers are

supplied with the Library Extender for this purpose.

12 Removing the USB device and

Ethernet cable from the lower Library

Remove the Ethernet cable and USB device from the lower Library. When

the Library Extender is installed, only the Ethernet and USB ports in the

upper Library are active.

Page 5

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

HP AG321A Guia de Início Rápido Página 5